www.tmatlantic.com
Test & Soldering Equipment On-line Store |
D.E.V.I.C.E. (Wiki)Calculators Services |
Filter by first letter
ABCDEFGHIJKLMNOPQRSTUVWXYZ+-
Reset |
OscilloscopesSearch by section D.E.V.I.C.E. services
The difference between the maximum and minimum values on the area.
The amount one waveform leads or lags another in time. Expressed in degrees, where 360 degrees comprise one waveform cycle.
For spectral analysis of oscilloscope signals there is algorithm of Fast Fourier Transform (FFT) widely used. This fast and powerful tool gives opportunities to investigate the signal spectrum but unfortunately it also has its own disadvantages.
A certain part of the waveform record which contains the readings registered after the trigger (postrecord).
Means the shoot measurement untill the voltage change on the rising edge RPREShoot and falling edge FPREShoot.
A certain part of the waveform record which contains the readings registered before the trigger (prerecord).
Probe is a matching unit used for oscilloscope inputs connection to the electric circuit points under test. Inaccuracy of signal data measurement, the correctness of the displayed waveform under survey depend on probes.
It is the time from the pulse beginning (the signal transmission over the median level on the rising edge) to its end (the signal transmission over the median level on the falling edge).
Pulse Width trigger occurs according to the width of pulse. In other words this trigger mode is used to catch the pulses of the specified width.
Articles 71 - 80 of 118 First | Prev. | 6 7 8 9 10 | Next | Last |
|
Site mapPrivacy policyTerms of Use & Store PoliciesHow to BuyShippingPayment |