Depending on a destination shipping cost may vary. Free shipping for orders over $450 on items weighting under 20 lbs (certain restrictions apply!) See shipping page for international rates or contact sales@tmatlantic.comSold out
Subscribe
Description
Specifications
Accessories
Application
FAQ
Descripción
AKTAKOM ATA-2502 is a clamp meter-adapter with analog output. If you connect it to a multimeter the measurement results will be displayed on the display of this multimeter. If you connect ATA-2502 to an oscilloscope you will be able of researching a signal waveform.
"Absolute measurement error" service allows you to estimate the measurement accuracy considering uncertainty (error) in the absolute value. It's important if you take measurements at the range edge when the error value contributes to the value displayed on the device screen.
To get the value range it'd be enough to enter the estimate of the value under measurement into Value input field and to see the range of possible values taking all of the standardized errors into consideration.
Note: a point is used as a separator of the integer and fractional part.
DC Current
Range
Resolution
Accuracy
Absolute error
Value-error
Value
Value+error
200 A
Unspecified
±(1.5%+1 digits)
±3 A
A
1000 A
Unspecified
±(2%+5 digits)
±20 A
A
AC Current
Range
Resolution
Accuracy
Absolute error
Value-error
Value
Value+error
200 A
Unspecified
±(1.5%+1 digits)
±3 A
A
1000 A
Unspecified
±(2%+5 digits)
±20 A
A
Hall effect sensor
Low battery indicator
Frequency range: 40...400 Hz
Output signal: 1 mV / 1 A (AC, DC)
User manual
AKTAKOM ATA-2502 es un adaptador de medidor de pinza con salida analógica. Si lo conecta a un multímetro, los resultados de la medición se mostrarán en la pantalla de este multímetro. Si conecta el ATA-2502 a un osciloscopio, podrá investigar una forma de onda de señal.