| www.tmatlantic.com
Test & Soldering Equipment On-line Store |
|
D.E.V.I.C.E. (Wiki)Calculators Services |
|||||
Filter by first letter
|
InterfacesSearch by section D.E.V.I.C.E. services
Router uses a receiver’s address shown in the data burst and with the help of the routing table identifies the route which should be used for the data transfer.
Serial bus and protocol for the connection between a measuring device and a PC.
RS-485 is a standard of a physical layer for an asynchronous interface. It regulates electrical parameters of half-duplex multipoint differential communication line of “common bus”-type.
SATA (Serial AT Attachment) is a computer bus interface that connects host bus adapters to mass storage devices such as hard disk drives, optical drives, and solid-state drives.
Switch is a network device destined for the connection of several Ethernet units into the common network segment. Comparing to a hub which distributes the traffic from one connected unit to the rest of units, switch transfers data to the receiver directly.
Designed for use with new Tektronix® oscilloscopes including the DPO7000 Series, TekVPI™ (Tektronix Versatile Probe Interface) probes provide intelligent bi-directional oscilloscope/probe communications resulting in a simplified user experience and easier access to relevant information while preserving excellent signal fidelity.
Thunderbolt™ technology is a transformational I/O innovation that provides a leap in performance over current I/O technologies with 10 Gbps of full-duplex bandwidth per channel.
USBTMC was introduced in order to support USB interface of test and measurement devices. For such devices there were lots of developments which used GRIB (IEEE488) commands therefore USBTMC is also the same commands-oriented.
USB features one "Universal" plug type for all USB peripheral-to-PC connections.
A device can represent a hub, a function or a combination of functions (compound device); port – connection point.
Articles 11 - 20 of 23 First | Prev. | 1 2 3 | Next | Last |
|