ATA-2504 Clamp Meter-adapter

AKTAKOM ATA-2504 is a clamp meter-adapter. If you connect it to a multimeter the measurement results will be displayed on the display of this multimeter. In case of connecting ATA-2504 to an oscilloscope you will be able of researching a signal waveform.

DC Current (DCA)	200 A
AC Current (ACA)	200 A
Jaw size	0.9 in / 23 mm

Specifications:

• Three ranges (4 A, 40 A, 200 A) in every measurement mode (AC/DC)
• Output signal: from 1 to 100 mV, 1 A (AC/DC)
• Frequency range: 40 Hz...1 kHz
• Hall effect sensor
• 2 batteries: 1.5V, AA-type
• Dimensions: 7.2 x 2.4 x 1.4 in / 183 x 61 x 36 mm
• Weight: 6.7 oz / 190 g

Direct current

Range	Output	Accuracy	Sensitivity
0...4 A*	100 mV/A	±(0.02 + 0,005 A)	0.1 mV/1 mA
0...40 A	10 mV/A	±(0.01 + 0,02 A)	0.1 mV/10 mA
0...150 A	1 mV/A	±(0.01 + 0,2 A)	0.1 mV/100 mA
150...200 A	1 mV/A	±(0.022 + 0,2 A)	0.1 mV/100 mA

* at the range of 4 A the output voltage can vary within 0.4 mV

Alternating current (with 40 Hz...1 kHz frequency)

Range	Output	Accuracy	Sensitivity
0...4 A	100 mV/A	±(0.02 + 0.005 A)	0.1 mV/1 mA
0...40 A	10 mV/A	±(0.015 + 0.03 A)	0.1 mV/10 mA
0...150 A	1 mV/A	±(0.015 + 0.3 A)	0.1 mV/100 mA
150...200 A	1 mV/A	±(0.022 + 0.2 A)	0.1 mV/100 mA

• Measurement probes
• Varrying case
• User manual

AKTAKOM ATA-2504 es un adaptador de medidor de pinza. Si lo conecta a un multímetro, los resultados de la medición se mostrarán en la pantalla de este multímetro. En caso de conectar el ATA-2504 a un osciloscopio, podrá investigar una forma de onda de señal.