Tronex Class W cutters are made entirely from solid tungsten alloy steel. This material is machined and formed at the Tronex factory to high dimensional tolerances with exceptionally sharp cutting edges and a solid joint design. The cutters undergo a special furnace-hardening process to achieve a hardness of 66 to 68 HRC on both cutting edges. (Cutters made of carbon steel have maximum edge hardness of 62 to 63 HRC.) CLASS W cutters have smaller tips than CLASS T cutters. This property enables these cutters to cut in more confined areas than CLASS T cutters. CLASS W cutters are lighter than CLASS T cutters. The cutting edges of CLASS W cutters are also less brittle than cutting edges of CLASS T cutters.
Depending on a destination shipping cost may vary. Free shipping for orders over $450 on items weighting under 20 lbs (certain restrictions apply!) See shipping page for international rates or contact sales@tmatlantic.comSold out
Subscribe
Description
Specifications
Accessories
Application
FAQ
Descripciуn
Tronex Fine Hard Wire 50° Thin Head Cutter 5084W, standard handle length, flush cutting edges.
Flush Cutting Edge: 0.29 in (7.6 mm). Handle Length: 4 in (102 mm).
Cutting capacity (steel wire): 0.003-0.007 in (0.08 mm-0.18 mm).
Cortador de cabeza fina Tronex de 50 ° de alambre fino duro 5084W, longitud de mango estбndar, filos al ras.