7049 Tip Miniature High Relief Ergonomic Handle Cutter

Tronex 7049 Tip Miniature High Relief Ergonomic Handle Cutter
Click an image to enlarge
Warranty:6 months

Tip cutter with deep relief for an exceptionally low profile. Short sturdy jaw. Razor Flush cutting edges.

Retail price :$82.13

Depending on a destination shipping cost may vary.
Free shipping for orders over $450
on items weighting under 20 lbs
(certain restrictions apply!)

See shipping page for international rates
or contact

Almost sold out,1left

BuyAdd to cart

Tronex Tip Miniature High Relief Ergonomic Handle Cutter 7049, ergonomic handle length, Razor Flush cutting edges.

Razor Flush cutting edge

There is no bevel on either cutting edge. The backside, or printed circuit board side, is absolutely flat at an angle of 45 degrees to the plane of the cutting surfaces. The exceptionally sharp edges produce cuts with virtually no raised surface on the lead. (Under a loupe you can see a line on the lead where the edges come together but you will not see a "pinch"). Also, minimum shock is imparted to the cut lead or component. However, more frequent sharpening is required with a Razor Flush cutter. The Razor Flush edge finish on Tronex cutters is executed by a proprietary process and thus unmatched by any other precision cutting tool in the world. It is also the edge finish selected for almost all specialty cutters (tip cutters and angulated cutters) made by Tronex.

Razor Flush® Cutting Edge: 0.17 in (4.4 mm). Handle Length: 4.8 in (122 mm).

Cutting capacity (soft copper wire): 0.004-0.025 in (0.1 mm-0.65 mm).

Cortador Tronex de muela miniatura con alto relieve para el corte, longitud filosa 4.4 mm (0.17 in), longitud de mango estndar; Filo tipo Razor Flush con ajuste de corte. Capacidad de corte (alambre de cobre blando): 0.004”-0.25” (0.1 mm-0.65 mm)

Filo tipo: Razor Flush

No hay bisel por ningn borde de corte. La parte posterior o lateral del circuito estampado es absolutamente plana en un ngulo de 45 grados respecto al plano de las superficies de corte. Los bordes excepcionalmente afilados producen cortes con prcticamente ningn reborde o rebarba. (Bajo una lupa se puede ver una lnea en la direccin donde los bordes se unen, pero no ver un "pellizco"). Adems de impartir un choque mnimo en el cable o sus componente. Sin embargo, con mayor frecuencia se requiere afilar con un cortador de Razor Flush. El acabado del filo Razor de los cortadores Tronex es ejecutado por un proceso patentado y por lo tanto no igualado por ninguna otra herramienta de precisin de corte en el mundo. Es tambin el acabado filoso seleccionado para casi todos los cortadores de la especialidad (cortadores de punta y cortadores angulados) hechos por Tronex.

Back to the section

Please give us your feedback to help us improve our website

* - required fields

Site map|Privacy statement|Terms of Use & Store Policies|How to Buy|Shipping|Payment|© T&M Atlantic, Inc.,2010-2018