Taper head cutters are very popular. The pointed head allows for increased cutting access yet has sufficient strength to avoid tip breakage when used within its capacity.
Depending on a destination shipping cost may vary. Free shipping for orders over $450 on items weighting under 20 lbs (certain restrictions apply!) See shipping page for international rates or contact sales@tmatlantic.comAlmost sold out, 1 left
Tronex Taper Head Standard Handle Razor Flush® Cutter 5223, standard handle length, Razor Flush® cutting edges.
Razor Flush® cutting edge
There is no bevel on either cutting edge. The backside, or printed circuit board side, is absolutely flat at an angle of 45 degrees to the plane of the cutting surfaces. The exceptionally sharp edges produce cuts with virtually no raised surface on the lead. (Under a loupe you can see a line on the lead where the edges come together but you will not see a "pinch"). Also, minimum shock is imparted to the cut lead or component. However, more frequent sharpening is required with a Razor Flush® cutter. The Razor Flush® edge finish on Tronex cutters is executed by a proprietary process and thus unmatched by any other precision cutting tool in the world. It is also the edge finish selected for almost all specialty cutters (tip cutters and angulated cutters) made by Tronex.
Razor Flush®Cutting Edge: 0.33 in (8.4 mm). Handle Length: 4.8 in (122 mm).
Cutting capacity (soft copper wire): 0.004-0.035 in (0.1 mm-0.9 mm).
Cortador Tronex de muela puntiaguda, longitud filosa 9.5 mm (0.4 in), longitud de mango estándar; Filo tipo Razor Flush con ajuste de corte. Capacidad de corte (alambre de cobre blando): 0.004”-0.35” (0.1 mm-0.9 mm).
Filo tipo: Razor Flush®
No hay bisel por ningún borde de corte. La parte posterior o lateral del circuito estampado es absolutamente plana en un ángulo de 45 grados respecto al plano de las superficies de corte. Los bordes excepcionalmente afilados producen cortes con prácticamente ningún reborde o rebarba. (Bajo una lupa se puede ver una línea en la dirección donde los bordes se unen, pero no verá un "pellizco"). Además de impartir un choque mínimo en el cable o sus componente. Sin embargo, con mayor frecuencia se requiere afilar con un cortador de Razor ® Flush. El acabado del filo Razor ® de los cortadores Tronex es ejecutado por un proceso patentado y por lo tanto no igualado por ninguna otra herramienta de precisión de corte en el mundo. Es también el acabado filoso seleccionado para casi todos los cortadores de la especialidad (cortadores de punta y cortadores angulados) hechos por Tronex.